r/s10 20h ago

Showing off my ride Grandparents gifted me their 1988 S10 Wrangler

Thumbnail
gallery
171 Upvotes

Just wanted to show off this gem that I was so lucky to be given.
How rare are these wrangler edition s10's?
Also roughly how much would this be worth? It's got 105,000km never seen winter. I don't plan to sell it, I'd just like to have a number in mind


r/s10 17h ago

Showing off my ride Had to run the portable air pump. Bike tires were flat for whatever reason. But thought the photo kinda looked cool. (Yes the bike and truck have the same tire valve caps lol).

Post image
22 Upvotes

r/s10 20h ago

Repair Question Ac problems

Post image
13 Upvotes

Recently overhauled ac on my 95 s10 still wasn’t getting cold air in cab. The accumulator is cold so ac is working. Replaced the ac/heat blend door actuator and the blend door will only stay open for heat and won’t close all the way for the cold air to come through the cab, it moves but not enough. Could my ac control in the dash be the issue?


r/s10 23h ago

Showing off my ride New-to-me 1998 Isuzu Hombre

9 Upvotes

Just bought this hombre from an older gent that kept it in his shop most of the time.

79k miles, 4.3L V6 with 4wd


r/s10 22h ago

Advice Making exhaust questions

Thumbnail
gallery
5 Upvotes

Im doing an exahsut loop for a sound im chasing. The loop tucks in real nice under the trans cross member on the passenger side but im wondering if the amount of pipes in one spot will overheat the floor. On a side note does the x pipe on top or under look better?


r/s10 8h ago

Aftermarket Parts I have a 2000 Chevy s10 but I don’t know much with audio

Post image
3 Upvotes

r/s10 21h ago

Repair Question Installed updated injectors are giving me a hard time how do I keep this connector in place? 4.3 engine

Post image
2 Upvotes

I finally got around to putting my engine back together after a lower intake manifold job after firing it up I had a misfire on cylinder three. I previously had this issue when I attempted to install it the first time and the tip got stuck inside the port I was able to fish it out and order a new tip just to be sure this wouldn’t happen again it seems the tip is able to separate from the injector somewhat easily is there anything I could apply or use to help keep them together?