Recently overhauled ac on my 95 s10 still wasn’t getting cold air in cab. The accumulator is cold so ac is working. Replaced the ac/heat blend door actuator and the blend door will only stay open for heat and won’t close all the way for the cold air to come through the cab, it moves but not enough. Could my ac control in the dash be the issue?

Just wanted to show off this gem that I was so lucky to be given.
How rare are these wrangler edition s10's?
Also roughly how much would this be worth? It's got 105,000km never seen winter. I don't plan to sell it, I'd just like to have a number in mind

I finally got around to putting my engine back together after a lower intake manifold job after firing it up I had a misfire on cylinder three. I previously had this issue when I attempted to install it the first time and the tip got stuck inside the port I was able to fish it out and order a new tip just to be sure this wouldn’t happen again it seems the tip is able to separate from the injector somewhat easily is there anything I could apply or use to help keep them together?

Im doing an exahsut loop for a sound im chasing. The loop tucks in real nice under the trans cross member on the passenger side but im wondering if the amount of pipes in one spot will overheat the floor. On a side note does the x pipe on top or under look better?