I have the original supervooc charger. I've charged my phone once with it, and once with the Anker. I think Anker reached the 55W output, since my phone went from 33% to 90% in about 30 minutes.

I noticed that the Anker didn't even leave the phone warm, while the supervooc did. 55 watts is perfectly fine to me, especially if it helps the longevity of the battery.

I have to wait a day or two for the battery to drain to test it again... I guess it's a good problem to have.

Hello people, i wanted suggestion about how do i remove the air bubble at the bottom of the phone? i got this glass installed from a local shop for 100rs and he had said that the bubble would go away after the phone warms up during charging after sometime. However it didn't go away. Any suggestions on how to remove it? The only thing is the guy said that he has the same type of tempered glass with him right now.

OnePlus Buds have a tiny screen behind the rubber nub. Ear wax gets in it. Mine was sounding bad. Used isopropyl alcohol and a toothbrush. Went from bad to can't hear shit. Tried with tape to clear it, failed. Tried again with a super soft tooth brush which could get into the tiny holes and it's night and day difference. You might not even notice how blocked they are.

So I accidentally upgraded my OP12R to 16 when the notification popped up

Not thrilled but it is what it is

Ever since, my weather app(Breezy) still uses its default icon in the lockscreen and banner

My Arcticons icons are applied everywhere else - even in Breezy itself

I can't tell if this is a OP issue or a Breezy compatibility issue, any ideas?

I have the OnePlus 15 China version and am considering switching to the global ROM. Since there are no local stores available to assist with the process in my area, I plan to do it myself. I have already backed up all data, including photos and WhatsApp, and am ready to proceed.My reasons for switching are as follows: First, I cannot access any AI features on the Chinese ROM. Second, the camera processing on ColorOS China ROM is poor—it over-whitens everything, especially when detecting faces, and the overall optimization is subpar as it is tailored specifically for Chinese users (this is my main motivation). Third, some apps like WhatsApp and Gmail fail to send notifications despite being set to auto-launch. Fourth, accessibility features reset every time the device restarts, which is highly frustrating.I am aware that Netflix may be limited to 480p, but I do not use it anyway. I also know there is no eSIM support, which I do not need. I will ensure OTA updates are available after the switch.Are there any other considerations I should keep in mind? Additionally, is the switch worth it?

Hi everyone,

I have a OnePlus 9 Pro with the original factory screen (it has never been replaced). After updating the phone, the fingerprint sensor stopped working.

I ran the diagnostics, and it says the fingerprint module needs calibration. From what I've read, this requires the OnePlus fingerprint calibration tool.

Has anyone experienced this before?

Were you able to fix it?

Is there a way to recalibrate the fingerprint sensor without replacing the screen?

Where can I get the official calibration tool or have the calibration done?

Any advice would be greatly appreciated. Thank you!